
Oscillating multi-tool rental in Espoo – cut, sand and scrape
Oscillating multi-tool rental in Espoo runs without a shop counter, a queue or a deposit. This is the tool for the awkward jobs: cutting a door frame flush so new flooring slides underneath, sanding into corners, scraping off old grout and glue. Blades and sanding sheets are in the case, along with two batteries. From 5,49 € at Iso Omena.
Quick facts
- Price: from 5,49 € (3 hours) · 14,99 € for a full day
- Rental time: 3 hours to 7 days
- Pick-up: Iso Omena, Piispansilta 11, floor −1, Espoo
- Open: every day, 6 am to midnight
- Speed: 22,000–40,000 oscillations/min, 3,2° angle
- Accessories: two blades, a scraper and nine sanding sheets included
- Deposit: none
Prices
- 3 hours - 5,49 €
- 6 hours - 7,99 €
- 12 hours - 9,99 €
- 24 hours - 14,99 €
- 2 days - 24,99 €
- 3 days - 31,99 €
- 7 days - 66,99 €
What you can do with it
- Cut a door frame or architrave flush to the floor so laminate slides underneath
- Sand into corners, edges and stair spindles where a normal sander will not reach
- Scrape off old grout, tile adhesive, silicone or layered paint
- Cut a neat opening in plasterboard for a socket, a pipe or a vent
- Trim a skirting board or a plinth that is already fixed to the wall
- Cut through a nail or a thin sheet of soft metal, using the segment blade
To be clear about the name: this is an oscillating multi-tool, the power tool whose blade vibrates through a 3,2° arc up to 40,000 times a minute. It is not the folding pocket tool that shares the word. The tiny stroke is the whole point - it cuts exactly on the line and right up against a surface, without kicking, wandering or needing room to swing. Slow for the amount of material it removes, and unbeatable where nothing else fits.
How oscillating multi-tool rental works
- Pick your slot online. Three hours covers a door frame and a stretch of grout; a full day covers a small bathroom strip-out.
- A PIN arrives by email. Open the locker at Iso Omena and lift out the case.
- Two batteries and a charger will keep the work going. Snap one in, keep the second in the charger, and swap when the first runs down.
- Change accessories on the magnetic quick-lock holder: press, swap, release. No spanner, no loose screw to drop into the floor cavity. Everything back in the case and back in the same locker.
Technical data
- Model: Einhell TE-MG 18 Li (Power X-Change)
- Type: Cordless oscillating multi-tool
- Battery voltage: 18 V Power X-Change
- Batteries supplied: 2 × 4,0 Ah, plus charger
- Oscillation speed: 22,000–40,000 per minute, electronically regulated
- Oscillation angle: 3,2°
- Accessory holder: magnetic quick-lock, 12-pin, tool-free
- Sanding pad: delta pad, 93 × 93 × 93 mm sheets
- Comfort: vibration-decoupled battery holder, soft-grip handle
- Weight: 1,3 kg, about 1,9 kg with a battery
- Case: hard carry case
What's in the case
- Einhell TE-MG 18 Li cordless oscillating multi-tool
- Delta sanding pad with nine sheets, three each of 60, 80 and 120 grit
- Plunge-cut blade for wood and plastic
- Segment saw blade for wood, plastic and soft metal
- Scraper blade
- Two 18 V Power X-Change batteries
- Charger
- Hard carry case
Not included: replacement blades and extra sanding sheets. What is in the case covers a normal job. If you are cutting hardwood, or lifting flooring that was glued down properly, expect the wood blade to go blunt before you finish, and pick up a spare from us before you start.
Rent or buy? An oscillating multi-tool is about 85 € new as a bare tool, and a battery and charger add roughly 50 €, so a comparable setup runs to around 135 €. A full day here is 14,99 €. This is the tool most people buy immediately after the job that needed it, because that is the moment they finally understand what it does. Rent it during the job instead. It earns its keep across a bathroom or a flooring weekend, and then sits still for years.
Frequently asked questions
- How much does it cost to rent an oscillating multi-tool in the Helsinki area? From 5,49 € for three hours or 14,99 € for a full day at Tooly, picked up from a smart locker at Iso Omena in Espoo. No deposit.
- Is there a deposit? No. You pay for the rental and nothing else.
- What accessories come with it? Two blades, a scraper and a delta sanding pad with nine sheets in three grits. That covers plunge cutting, segment cutting, scraping and sanding, which is the whole point of the tool. Replacement blades are on sale at Tooly.
- When should I use this instead of a jigsaw or a saw? When the cut has to finish flush against something, or start in the middle of a surface, or happen in a space too tight to swing anything. A jigsaw needs a flat surface to sit on and room to run. This one just presses in where it needs to cut. It is far slower, so use it for the last 5 % of a job, not the first 95 %.
- Can it cut metal? Soft metal, yes, with the segment blade: nails, thin sheet, small fixings. Run it at a lower speed than you would for wood and let the blade cool, because heat is what kills these blades rather than wear. Hardened steel and thick bolts need a different tool.
Pick-up and opening hours: The Tooly locker is on floor −1 of the Iso Omena shopping centre, Piispansilta 11, Espoo, near the Musti ja Mirri entrance. It is open every day from 6 am to midnight, so you can collect before work or after the shops close. Matinkylä metro station is in the same building, and this is the lightest tool in our range, so no car needed.
Pricing
| Period | Rate | Total |
|---|---|---|
| 3 hours | 1,83 €/hr | 5,49 € |
| 6 hours | 1,33 €/hr | 7,99 € |
| 12 hours | 0,83 €/hr | 9,99 € |
| 24 hours | 0,62 €/hr | 14,99 € |
| 2 days | 0,52 €/hr | 24,99 € |
| 3 days | 0,44 €/hr | 31,99 € |
| 7 days | 0,4 €/hr | 66,99 € |
Need a different duration? Custom durations available in booking.
Book this item
Complete the steps to continue
City
Select pick-up point
Duration
Start date
Start time
Confirm
Book this item
Complete the steps to continue
City
Select pick-up point
Duration
Start date
Start time
Confirm
Oscillating Multi-Tool Einhell
from 0,40 €/hr